![]() ![]() Please let us know if you need anything else to get the problem fixed. To install, reverse the removal procedure.įill the power steering system. NOTE: Make sure the pressure line is routed correctly. Position the cable and retainer away from the pressure line. Pinch the selector lever cable retainer clips together and carefully pull outward to detach the cable from the cable bracket.Ĭarefully pull outward on the cable end to detach it from the shift shaft lever. Ford Edge Fuse Diagram for Battery Junction Box and Smart Junction Box This 2010 Ford Edge Fuse Box Layout post shows two fuse. Release the pressure line from the 4 pressure and return line retainers.ĭisconnect the selector lever cable from the transmission. ![]() Remove the steering line clamp plate bolt and rotate the clamp plate. Remove the steering line-to-steering gear retainer bolt and release the pressure line from the retainer.ĭisconnect the pressure line from the steering gear. Remove the nut from the pressure line bracket-to-starter stud and position the pressure line bracket aside. Position the A/C line and pressure line brackets off the A/C compressor stud.ĭetach the oil pressure sending unit wiring harness retainer from the pressure line bracket-to-starter stud. Remove the pressure line-to-A/C compressor stud nut. Remove the A/C compressor line bracket from the A/C compressor stud.ĭetach the wiring harness pin-type retainer from the bracket. 2010 FORD EDGE POWER STEERING PUMP PULLEY MOTOR ASSEMBLY OEM 9T43-3A696-AA (Fits: 2008 Ford Edge) 74.99. Free shipping on many items Browse your favorite brands. To install, tighten to 20 Nm (177 lb-in).ĭisconnect the pressure line fitting from the power steering pump. Get the best deals on Power Steering Pumps for 2008 Ford Edge when you shop the largest online selection at. Remove the PSP sensor from the pressure line. Notes : M14 x 1. For additional information, refer to Power Steering Pump Pulley See: Power Steering PumpService and RepairPower Steering Pump Pulley.ĭisconnect the Power Steering Pressure (PSP) sensor electrical connector. Position the connector and the wiring harness away from the pressure line. ![]() NOTICE: Do not allow power steering fluid to contact the accessory drive belt or damage to the belt may occur.ĭetach the pressure line from the pressure and return line retainer.ĭisconnect the Turbine Shaft Speed (TSS) sensor electrical connector at the transmission. NOTICE: While repairing the power steering system, care should be taken to prevent the entry of foreign material or failure of the power steering components may result. It is the hose from the pump to the steering rack with diagrams below with the instructions on how to change out the power steering hoses. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |